I will need the length of the armscye later in my project when drawing the sleeve.
So, I need the lenght of all the segments between the point SAPV and A6
At first glance I did not find a measurement tool that allows me to [cltr] click on a series of contiguous segments to give me a running total of their resp. lengths.
What I did was: I went into the ‘Table of variables’ and added all the values manually (could not even copy them to the calculator as right-click does not work in the table of variables) from the ‘lengths curves’ and ‘lines’ which make up my armscye and wrote the value on a post-it.
I know that there must be a simpler solution than an off-line post-it to keep track of temporary data within the project, but I did not find it.
Any help is appreciated.